Problem Case 1:
The motor is a 100W DC motor, the bag making machine is a light-controlled bag machine, the bag making machine is designed to do 4 at the same time, now found that the motor is often hot, and the original has burned two motors, how to solve the problem of high humidity of the motor after the bag making machine? Some people say that you can adjust the speed of the motor, so that it is the same as the speed of the front cutting bag, but (we open two motors at the same time, do two) such a method can only adjust the speed of one of the motors, the other can not be adjusted, how to solve? And if the motor speed is slowed down, then the film is easy to tear, how to find the best speed?
Technical department to solve problems:
If the design problem is 100W power is not enough to increase the power.
If it is not a design problem, a simple way to add heat.
Complex points plus feedback circuits. Make the front and rear motor coordinate action.
When we make toilet paper roll packaging, we use a pneumatic water-cooled sealer, which uses water circulation to control the sealing and cutting temperature. If possible, consider the water circulation to ensure constant temperature operation so as not to burn the machine
