The selection of the screw structure of the plastic extruder is mainly determined according to the physical properties of the plastic and the production technical specifications of the extruder.
1.The softening of the amorphous compound is completed in a relatively wide temperature.Generally,isometric gradual screw is used.The melting temperature range of crystalline polymers is relatively narrow,and isometric abrupt screws are generally used.
2.On small plastic rctruders,such as the p45 extruder,the screw adopts a fully threaded type with equal intervals and unequal depths.The length of the screw is relatively small,and it is mainly used for extruding small cross-section insulation and sheath layers.The extrusion speed is faster.
3.The medium-sized screw adopts a full-thread type with equidistant and gradual twisting depth.Its length-to-diameter ratio is larger than of a small screw,and the pitch of the threads is equal,starting from the root from shallow to deep.The thread at the end of the thread is deeper and the thread at the root is ahallow.In this way,the amount of plastic extrusion is more,but not
Affects the strength of the screw,the extrusion speed is fast,and the plastic is well plasticized.It is an ideal screw for the production of insulating and sheath layers on general small and medium extruders.



