Plastics are extracted from petroleum.With the continuous reduction of petroleum resources,from the perspective of environmental protection, most plastics have achieved the process of "recycling",but waste plastics can only be completed through classification,cleaning,drying,granulation and other steps.The existence of plastic granulator can further realize the effect of recycling plastics.
After the crushing is completed,the plastic wire containing hardware shall be floated with salt water to separate the plastic from the hardware.The crushed plastic shall be melted and granulated with a plastic granulator.
The current plastic granulator can sort a variety of plastic with purity >90 #. The principle is to use infrared ray.
After the circulation is completed,the components are in a retracted state,allowing the hydraulic oil in the pipeline to flow back to the tank with greater capacity.After the plastic granulator goes out automatically,discharge the oil in the oil tank,hydraulic cylinder,pipeline,travel control motor and accessories of the electronic hydraulic system.
After normal operation,feed materials as soon as possible,observe the plastic melting and adjust the temperature.During the production process,the temperature can be properly adjusted according to the raw materials,water content and discharge conditions.It is not allowed to copy mechanically.It is necessary to flexibly control and master the appropriate temperature.
