Heating Modification steps of film blowing machine
1.The original heating ring of the modified barrel should be removed.
2.Measure the size of the barrel,generally including the length of the circumference.Calculate the required thermal insulation cotton and estimate whether the winding position is enough according to the power of the original heating ring.
3.Warp the insulation cotton on the barrel and tie it with a high temperature bandage to keep the thickness of the insulation cotton at about 1.5-2.0CM.In order to make the insulation cotton insulating resin board.
4.Wind the electromagnetic wire on the wrapped barrel,and the wound electromagnetic wire should be as close as possible.
5.Install electromagnetic heating control cabinet.
