1.The power switch of the electric halo processor should be turned off first.
2.Turn off the heater and the heater on the fuselage.
3.Low-speed running machines make the extruder and the mold cool down slowly.
4.After the temperature of the temperature control table drops below 135° C,stop the operation of the extruder,and turn off the pull-up and papers.Cut off the power switch and turn off the compressed air switch.
5.Remove the film on the scroll,pound,packaging and warehouse.
6.Clean up the leftovers of the extrusion machines and clean the sanitation of the ground and equipment.
