1. Start the main motor, run at low speed, then adjust the edge control, and divide the membrane in the middle position.
2. Adjust the left and right chucking rollers to align the left and right films, and adjust the front and back chucking rollers to align the pattern.
3. Adjust the heat sealing knife to make it within the required range of the bag.
4. Adjust the slitting blade to the desired position, and adjust the punching position to the scissors mouth.
5. Preliminarily adjust the machine speed, take a flat sample bag for preliminary inspection, if it does not meet the specified requirements, take another flat sample bag for heat sealing value test.
6. Tidy out the bags produced, select the bags with quality defects (such as folds, tunnels, flower width, knife lines, poor thermal bonding, four seals, etc.), and bundle them well according to the regulations.
7. By the machine quality inspector for inspection, such as qualified inspection, affixed with the certificate of qualification, into the quality inspection room sampling.
8. During the production process, observe the bag-making situation at any time and adjust it immediately if any abnormance is found.
