1. Product specification, type (side seal, middle seal, etc.), cutting position, heat-sealing line, heat-sealing line specification and other requirements shall be defined.
2. Parts need to be replaced according to product type. For the middle seal pocket, the iron plate should be replaced according to the width of the product (the width of the iron plate is usually 2-3 cm smaller than the width of the product), and the heat sealing mold should be replaced according to the specifications of the heat sealing line. Feeding, making and heating should be adjusted according to the thickness and melting point of the material.
3. The cutting position of the product shall be adjusted to the position of the cutting knife according to the specifications of the packaging bag, and the position of the heat sealing die shall be adjusted according to the position of the heat sealing line of the product. Adjust the sensitivity of the front and rear electric eyes according to the color brightness of the product pattern, and adjust the position of the electric eyes.
4. When making bags, make sure to check whether the heat sealing temperature of the products is moderate (if the temperature is too high, the bags will wrinkle; if the temperature is too low, the bags will not be hot). In addition, check regularly whether the product specifications, heat sealing position, heat sealing line specifications and cutting position meet the requirements.




